Commercial Boxing Frame Installation Guide

Xpeed Commercial Boxing Frame — Installation Guide

⚠ Important:
Installation should be completed by a competent person with experience in fixing heavy-duty equipment. Incorrect installation may result in injury or product damage.

Tools & Hardware Required

• 150mm x M12 Thunderbolt anchors (recommended: 4 pieces)

• Hammer drill with masonry bit (12mm)

• Socket wrench or spanner (19mm)

• Spirit level

• Marker or chalk

• Protective equipment (safety glasses, gloves, ear protection)

Step-by-Step Installation

1. Position the Frame

   • Place the frame in the desired location, ensuring adequate clearance around the punching bag for safe training.

   • Check for overhead clearance of at least 60cm above the bag.

2. Mark Mounting Points

   • Use a spirit level to ensure the upright is vertical.

   • Mark the four base plate holes on the floor.

3. Drill Anchor Holes

   • Using a hammer drill with a 12mm masonry bit, drill holes to the required depth for the Thunderbolt anchors (approx. 150mm).

   • Remove dust from holes to ensure a secure fit.

4. Install Anchors

   • Position the frame over the drilled holes.

   • Insert Thunderbolt anchors through the base plate holes and tighten with a socket wrench until fully secure.

5. Check Stability

   • Ensure the frame is firmly fixed and level.

   • Test the rotation mechanism of the bag attachment before hanging the punching bag.

6. Attach the Punching Bag

   • Hang the bag according to the manufacturer’s instructions.

   • Double-check all fixings before first use.